USB-FE02-V01-X

EbEmbeddddedd USBUSB PProbbe Overvview Inter-CChip USB (IC-USB) specification (Reference A) dfdefiinees a sttanddardd metthhdlodology ffor usiing USBUSB iin chihip-tto- chip coommunications. It is used in the embedded systemms market as a replacement for i2C to control data transfeers between endpoint functions within an embeddded device. IC-USB allows vendors to leverage on- board embedded USB host logic to enable faster chip-to- chip coommunications using USB physical links within a multilti-cchhiip PCBPCB assemblbly. Teledyyne LeCroys embedded probe supports tapping these chip-to-chip links using low or full speed Inter-chip signalss at all defined IC-USB voltages. The probe can also be useed to tap USB 2.0 links at standard 3.3 volt signal levels.. ThThe emmbbeddddedd probbe utilitilizes a 44-wiihre headder pllug tthhatt can bee attached as a solder down tap or as flying lead conneection attached directly to header pins on the DUT. Probinng techniques above can be used for both USB 2.0 compliant electrical links or low/full speed Inter-chip links. The USB protocol traffic can be monitored (via the D+/D- wires) by attaching the probe to the A port of a Teledyne LCLeCroyy USBUSB anallyzer.Probe Specifications Operational Characteristics: A 4-wire tap allows solder down directly between chipp-to-chip connections on a PCB. For IC-USB links, a high- fidelity amplifier is used to increase signal amplitude tto valid USB 1.1/2/0 voltages. Supported voltages defined by the Inter-Chip USB (IC-USB) specification (Reference A) include: 1.1.00 VV 1.1.55VV 3.03.0 VV 3.3V 1.2V 1.8 V (standard USB 1.1/2.0 voltage) Probe Components: Header plug allows connection to the female porrtion of probe lead assembly Two flying lead probe sets (6 for IC-USB links 22 for high-speed USB 2.0 links) Solder in resistor probe tips Two type A USB connections (One USB cablee for power one cable for connection to analyzer) Temperature and Humidity The probe will operate in the following temperature raange: Operating: 0C to 55C (31F to 131F) Non-operating: -20C to 80C (-4F to 176F) The hardware will operate in the following humidity raange: 10% to 90% RH (non-condensing) Ordering Information Product Description: Embedded USB Probe Product Part Number: USB-FE02-V01 1-800-909-7211 Local sales offices are located throughout the world. teledynelecroy.com Visit our website to find the most convenient location. 2013 Teledyne LeCroy. All rights reserved. Specifications, prices, availability and deliivery subject to change without notice. psgusbembeddedds 0713 Product or brand names are trademarks or requested trademarks of their respective hoolders.