LC241

PCB Mount Datasheet LC Series Mini-SIP SSR Ratings to 2A 280 VAC Dual SCR output (normally open) DC control Zero Voltage (resistive loads) or Instantaneous Turn-on (inductive loads) output Plastic encapsulated PRODUCT SELECTION Control Voltage 1.5A 2A 4-10 VDC LC241 LC242 AVAILABLE OPTIONS Operational Current 1: 1.5 Amps 2: 2 Amps Series LC 24 1 R Operational Voltage Switching Type 24: 12-280 VAC Blank: Zero Voltage Turn-On R: Instantaneous Turn-On Required for valid part number For options only and not required for valid part number (1) OUTPUT SPECIFICATIONS Description LC241 LC242 Operating Voltage (47-63Hz) Vrms 12-280 12-280 Transient Overvoltage Vpk 600 600 Maximum Off-State Leakage Current Rated Voltage mArms 0.1 0.1 Minimum Off-State dv/dt Maximum Rated Voltage V/sec (2) 500 500 Maximum Load Current Arms 1.5 2.0 Minimum Load Current Arms 0.025 0.025 Maximum Surge Current (16.6ms) Apk 80 100 Maximum On-State Voltage Drop Rated Current Vpk 1.6 1.5 Minimum Power Factor (with Maximum Load) 0.5 0.5 (1) INPUT SPECIFICATIONS Description Parameters Control Voltage Range 4-10 VDC Must Turn On Voltage 4.0 VDC Must Turn Off Voltage 1.0 VDC Typical Input Current 5 VDC 15 mAdc Nominal Input Impedance 300 Ohm Maximum Turn-on Time msec (3) 1/2 Cycle 1/2 Cycle Maximum Turn-Off Time msec Do not forget to visit us at: www.crydom.com Copyright 2016 Crydom Inc. Specifications subject to change without notice. ObsoletePCB Mount Datasheet (1) GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) (4) 2500 Vrms 9 10 Ohm Minimum Insulation Resistance ( 500 VDC) Maximum Capacitance, Input/Output 10 pF Ambient Operating Temperature Range -30 to 80 C Ambient Storage Temperature Range -30 to 125 C Weight (typical) 0.6 oz. (17 gr) Encapsulation Thermally Conductive Epoxy GENERAL NOTES (1) All parameters at 25C and per section unless otherwise specied. (2) Off-State dv/dt test method per EIA/NARM standard RS-443. (3) O.1 msec for random turn-on version (R sufx). (4) Dielectric and isulation resistence are mesasured between input and output. MECHANICAL SPECIFICATIONS Tolerances: 0.02 in / 0.5 mm All dimensions are in: inches millimeters .950 .200 24.1 5.1 .500 12.7 LC242 LOAD CONTROL + - .250 1 2 3 4 6.3 0.30 .100 0.8 2.5 .015 0.4 .500 12.7 .150 3.8 .700 17.8 THERMAL DERATE INFORMATION AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 E116950 Rev 031416 Do not forget to visit us at: www.crydom.com Copyright 2016 Crydom Inc. Specifications subject to change without notice. Obsolete