DC500F60C

Panel Mount Datasheet Power Plus DC Series Ratings from 60 A 500 VDC DC control Mosfet Output EMC Compliant to Level 3 LED Status Indicator Epoxy Free Design UL Approved, CE Compliant to EN60950-1 Improved SEMS screw and washer Redesigned housing with anti-rotation barriers PRODUCT SELECTION Control Voltage 60 A 4-32 VDC DC500D60 30-60 VDC DC500F60 AVAILABLE OPTIONS Termination Blank: Screws & clamps Control Voltage K: Installed standoffs with (1) Thermal Pad D: 4-32 VDC screws for PC Board Blank: Not Included Series F: 30-60 VDC mounting (IP00 only) H: Included DC 500 D 60 K C H Operating Voltage Cover Rated Load Current Blank: Not Included (IP00) 500: 1-500 VDC 60: 60 Amps C: Included (IP20) Required for valid part number For options only and not required for valid part number Not all part number combinations are available. * Contact Crydom Technical Support for information on the availability of a specific part number. (2) OUTPUT SPECIFICATIONS Description 60 A Recommended Operating Voltage Vdc 1-500 Absolute Maximing Rating Vdc 500 Maximum Off-State Leakage Current Rated Voltage mA 0.1 Maximum Load Current Adc (1)(3) 60 Minimum Load Current mA (4) 2.5 Maximum Surge Current (10msec) Adc 95 Maximum On-State Voltage Drop Rated Current Vdc 0.8 Maximum On-State Resistance RDS-ON Ohms 0.013 Thermal Resistance Junction to Case (Rjc) C/W 0.25 Minimum Heat Sink for Rated Current 40C C/W 0.7 Maximum Pulse Width Modulation Frequency Hz (5) 500 (2) INPUT SPECIFICATIONS Description Option D Option F Control Voltage Range 4-32 VDC 30-60 VDC Maximum Reverse Voltage -32 VDC -60 VDC Minimum Turn-On Voltage (6) 4 VDC 30 VDC Must Turn-Off Voltage 1 VDC 20 VDC Minimum Input Current (for on-state) 11 mA 12 mA Maximum Input Current 14 mA 17 mA Nominal Input Impedance Current Regulated Current Regulated Maximum Turn-On Time sec 100 100 Maximum Turn-Off Time sec 100 100 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright 2020 Crydom Inc. Specifications subject to change without notice.Panel Mount Datasheet (2) GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) 3750 Vrms 9 Minimum Insulation Resistance ( 500 VDC) 10 Ohms Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range (7) -40 to 100 C Ambient Storage Temperature Range -40 to 125 C Weight (typical) 2.88 oz (81.53 g) Housing Material UL94 V-0 Hardware Finish Nickel Plating Baseplate Material Aluminum Input Terminal Screw Torque Range (in-lb/Nm) 13-15 /1.5-1.7 Load Terminal Screw Torque Range (in-lb/Nm) 18-20 / 2-2.2 SSR Mounting Screw Torque Range (in-lb/Nm) 18-20 / 2-2.2 Input/Load Terminal Screw Torque Range (in-lb/Nm) (1) w/K option 8-10 / 0.9-1.13 Input/Output Terminal Screw Thread Size 6-32 UNC / 8-32 UNC Humidity per IEC60068-2-78 93% non-condensing LED Input Status Indicator Green 21,395,130 hours (2,441 years) MTBF (Mean Time Between Failures) at 40C ambient temperature (8) 11,545,504 hours (1,317 years) MTBF (Mean Time Between Failures) at 60C ambient temperature (8) WIRING DIAGRAM * Inductive loads must be diode suppresed. + Recommended Wire Sizes + - V * * V Load Load Wire Size Wire Pull-Out - + Terminals + (Solid / Stranded) Strength (lb) N 2 24 AWG (0.2 mm ) / 0.2 minimum 10 44.5 Input 2 2 x 12 AWG (3.3 mm ) / 3.3 maximum 90 400 +2 +2 2 1 OUTPUT 1 OUTPUT 20 AWG (0.5 mm ) / 0.518 minimum 30 133 S OL I D S T A T E R EL A Y S OL I D S T A T E R EL A Y Output 2 2 x 10 AWG (5.3 mm ) / 5.3 110 490 4 INPUT +3 4 INPUT +3 2 2 x 8 AWG (8.4 mm ) / 8.4 maximum 90 400 + + Input Current vs Input Voltage V V - - DC500D60 14 12 10 EQUIVALENT CIRCUIT BLOCK DIAGRAMS 8 6 4 2 33 22 0 +DC +DC 0 5 10 15 20 25 30 35 DC Input Voltage Control Trigger Circuit Circuit Input Current vs Input Voltage DC500F60 -DC 44 11 -DC 14 Current 12 Limiter 10 8 6 4 2 0 0 5 10 15 20 25 30 35 40 45 50 55 60 Do not forget to visit us at: www.crydom.com Copyright 2020 Crydom Inc. Specifications subject to change without notice. INPUT OUTPUT Input Current (mA) Input Current (mA)