WWW.PHIHONG.COM Low Cost 30W Passive Power over Ethernet Injector Features Gigabit Data rates Low Cost Level VI Efficiency Full Protection OCP, OVP Very Low leakage 1 Year Warranty Non-Vented Case Applications IP Telephones (W Model Recommended) Security Camera Wireless Network Access Points IP Print Servers Blue Tooth Access Point Wimax APs Safety Approvals cUL/UL CE Mechanical Characteristics Length: 140mm (5.51in) Height: 36mm (1.42in) Width: 65mm (2.55in) Weight: 225g (0.44lb.) Output Specifications Model Number Output Voltage Output Current Input Connector POE29U-560-R 56V 0.54A 3 Wire C14 Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 12/11/2018 POE29U-560 Characteristics WWW.PHIHONG.COM INPUT: AC Input Voltage Range Isolation Test 90 to 264VAC Primary to Secondary: 3000VAC for 1 minute 10mA AC Input Voltage Rating Primary to F.G.: 1500VAC for 1 minute (U 100 to 240VAC, 47-63Hz models) Output to F.G.: 1500VAC (U models) AC Input Current 0.8A (RMS) maximum for 120VAC Immunity 0.5A (RMS) maximum for 240VAC ESD: EN61000-4-2. Level 3 RS: EN61000-4-3. Level 2 Leakage Current EFT: EN61000-4-4. Level 2 350uA maximum 264VAC 60Hz Surge: EN61000-4-5. Level 3 CS: EN61000-4-6. Level 2 AC Inrush Current Voltage Dips EN61000-4-11 30A (RMS) maximum for 115VAC Harmonic: EN61000-3-2 Class A 60A (RMS) maximum for 240VAC Insulation Resistance OUTPUT: Primary to Secondary: >10M OHM Total Output Power 500VDC 30W Primary to Field Ground: >10M OHM 500VDC Output Ripple 560mVp-p FEATURES: Over Voltage/Current, Short Circuit No Load Power Consumption Protection <0.1W Outputs equipped with short circuit protection and overload protection. Efficiency The output can be shorted permanently Meets Level VI Efficiency Requirements without damage Hold-up Time Input Connector 10mS min. 120VAC and maximum load IEC320 C14 ENVIRONMENTAL: Output Connection Temperature +pin 3, 6 / -pins 1, 2 Operation -20 to +50C Non-operation -25 to +70C Humidity 20 to 90% EMC Complies with FCC Class B Complies with EN55032 Class B Revision 12/11/2018