MC56F8367VPYE

56F8367/56F8167 Data Sheet Preliminary Technical Data 56F8300 16-bit Digital Signal Controllers MC56F8367 Rev. 9 11/2009 freescale.com Document Revision History Version History Description of Change Rev 0 Pre-release, Alpha customers only Rev 1.0 Initial Public Release Rev 2.0 Added output voltage maximum value and note to clarify in Table 10-1. also removed overall life expectancy note, since life expectancy is dependent on customer usage and must be determined by reliability engineering. Clarified value and unit measure for Maximum allowed P in Table 10-3. Corrected note about average value for Flash Data D Retention in Table 10-4. Added new RoHS-compliant orderable part numbers in Table 13-1. Rev 3.0 Added 160MAPBGA information, TA equation updated in Table 10-4 and additional minor edits throughout data sheet Rev 4.0 Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in Table 10-4. Added RoHS-compliance and pb-free language to back cover. Rev 5.0 Correcting MBGA pin assignments in Table 2-2 for MOSI0 and MISO0 Rev 6.0 Added information/corrected state during reset in Table 2-2. Clarified external reference crystal frequency for PLL in Table 10-14 by increasing maximum value to 8.4MHz. Rev 7.0 Corrected CLKO and HOME1 labels in Figure 11-2 and Table 11-2 replaced Tri-stated with an explanation in State During Reset column in Table 2-2. Added the following note to the description of the TMS signal in Table 2-2: Rev. 8 Note: Always tie the TMS pin to V through a 2.2K resistor. DD Added the following note to the description of the TRST signal in Table 2-2: Note: For normal operation, connect TRST directly to V . If the design is to be used in a SS debugging environment, TRST may be tied to V through a 1K resistor. SS Add Figure 10-1 showing current voltage characteristics. Rev. 9 In Table 10-24, correct interpretation of Calibration Factors to be viewed as worst case factors. Please see