56F8366/56F8166 Data Sheet Preliminary Technical Data 56F8300 16-bit Digital Signal Controllers MC56F8366 Rev. 7 11/2009 freescale.com Document Revision History Version History Description of Change Rev 0 Pre-release, Alpha customers only Rev 1.0 Initial Public Release Rev 2.0 Added output voltage maximum value and note to clarify in Table 10-1 also removed overall life expectancy note, since life expectancy is dependent on customer usage and must be determined by reliability engineering. Clarified value and unit measure for Maximum allowed P in Table 10-3. Corrected note about average value for Flash Data Retention in Table 10-4. D Added new RoHS-compliant orderable part numbers in Table 13-1. Rev 3.0 Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in Table 10-4. Added RoHS-compliance and pb-free language to back cover Rev 4.0 Added information/corrected state during reset in Table 2-2. Clarified external reference crystal frequency for PLL in Table 10-14 by increasing maximum value to 8.4MHz. Rev 5.0 Replaced Tri-stated with an explanation in State During Reset column in Table 2-2. Added the following note to the description of the TMS signal in Table 2-2: Rev. 6 Note: Always tie the TMS pin to V through a 2.2K resistor. DD Added the following note to the description of the TRST signal in Table 2-2: Note: For normal operation, connect TRST directly to V . If the design is to be used in a debugging SS environment, TRST may be tied to V through a 1K resistor. SS Remove pullup comment from PWM pins in Table 2-2. Rev. 7 Add Figure 10-1 showing current voltage characteristics. In Table 10-24, correct interpretation of Calibration Factors to be viewed as worst case factors. Please see