MC56F8156VFVE

56F8356/56F8156 Data Sheet Preliminary Technical Data 56F8300 16-bit Digital Signal Controllers MC56F8356 Rev. 13 01/2007 freescale.com Document Revision History Version History Description of Change Rev 1.0 Initial Public Release Rev 2.0 Added Package Pins to GPIO Table in Part 8 General Purpose Input/Output (GPIO). Added Typical Min values to Table 10-18. Editing grammar, spelling, consistency of language throughout family. Updated values in Regulator Parameters Table 10-9, External Clock Operation Timing Requirements Table 10-13, SPI Timing Table 10-18, ADC Parameters Table 10-24, and IO Loading Coefficients at 10MHz Table 10-25. Rev 3.0 Added Part 4.8, added the word access to FM Error Interrupt in Table 4-5, documenting only Typ. numbers for LVI in Table 10-6, updated EMI numbers and writeup in Part 10.8. Rev 4.0 Updated numbers in Table 10-7 and Table 10-8 with more recent data, Corrected typo in Table 10-3 in Pd characteristics. Rev 5.0 Replace any reference to Flash Interface Unit with Flash Memory Module corrected thermal numbers for 144 LQFP in Table 10-3 removed unneccessary notes in Table 10-12 corrected temperature range in Table 10-14 added ADC calibration information to Table 10-24 and new graphs in Figure 10-22 Rev 6.0 Adding/clarifing notes to Table 4-4 to help clarify independent program flash blocks and other Program Flash modes, clarification to Table 10-23, corrected Digital Input Current Low (pull-up enabled) numbers in Table 10-5. Removed text and Table 10-2 replaced with note to Table 10-1. Rev 7.0 Added 56F8156 information edited to indicate differences in 56F8356 and 56F8156. Refor- matted for Freescale look and feel. Updated Temperature Sensor and ADC tables, then updated balance of electrical tables for consistency throughout family. Clarified I/O power description in Table 2-2, added note to Table 10-7 and clarified Section 12.3. Rev 8.0 Added output voltage maximum value and note to clarify in Table 10-1 also removed overall life expectancy note, since life expectancy is dependent on customer usage and must be determined by reliability engineering. Clarified value and unit measure for Maximum allowed in Table 10-3. Corrected note about average value for Flash Data Retention in Table 10-4. P D Added new RoHS-compliant orderable part numbers in Table 13-1. Rev 9.0 Updated Table 10-24 to reflect new value for maximum Uncalibrated Gain Error Rev 10.0 Deleted RSTO from Pin Group 2 (listed after Table 10-1). Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient Operating Temperature (Industrial) in Table 10-4. Added RoHS-compliance and pb-free language to back cover. Rev 11.0 Added information/corrected state during reset in Table 2-2. Clarified external reference crys- tal frequency for PLL in Table 10-14 by increasing maximum value to 8.4MHz.. Rev 12.0 Replaced Tri-stated with an explanation in State During Reset column in Table 2-2. Added the following note to the description of the TMS signal in Table 2-2: Rev. 13 Note: Always tie the TMS pin to V through a 2.2K resistor. DD Added the following note to the description of the TRST signal in Table 2-2: Note: For normal operation, connect TRST directly to V . If the design is to be used in a debugging SS environment, TRST may be tied to V through a 1K resistor. SS Please see