MP2002 Low Input Voltage 500mA Linear Regulator NOT RECOMMENDED FOR NEW DESIGNS DESCRIPTION FEATURES Power Good Open Collector Output The MP2002 is a low-current, low-dropout Operates from 1.35V 6.5V Input linear regulator operating over a single input supply between 1.35V to 6.5V. The output Low 300mV Dropout at 500mA Output voltage of the MP2002 is adjustable via an Stable with Very Small Ceramic Capacitors external resistor divider. The MP2002 can 2% Feedback Reference supply up to 500mA of load current. The enable Adjustable Output Voltage Option from 0.5V pin (EN) allows the part to be put into a low to 5V using an External Resistor Divider current shutdown mode (EN=0). The MP2002 Better Than 0.001%/mA Load Regulation features thermal overload and current limit Low 100A Ground Current protection. It is available in an 8-pin QFN (2 x Internal Thermal Protection 3mm) package Current Limit Protection 6A Typical Quiescent Current at Shutdown Available in a Tiny 2 x 3mm 8-pin QFN Package APPLICATIONS Low Current Regulators Battery Powered Systems Cellular Phones For MPS green status, please visit MPS website under Quality Assurance. MPS and The Future of Analog IC Technology are Registered Trademarks of Monolithic Power Systems, Inc. TYPICAL APPLICATION MP2002 Rev. 1.11 www.MonolithicPower.com 1 10/10/2011 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited. 2021 MPS. All Rights Reserved. MP2002 LOW INPUT VOLTAGE, 500mA LINEAR REGULATOR NOT RECOMMENDED FOR NEW DESIGNS ORDERING INFORMATION Part Number* Package Top Marking Free Air Temperature (TA) QFN8 (2 x 3mm) MP2002DD L7 -40 C to +85 C * For Tape & Reel, add suffix Z (eg. MP2002DDZ) For RoHS Compliant Packaging, add suffix LF (eg. MP2002DDLFZ) PACKAGE REFERENCE (4) (1) Thermal Resistance JA JC ABSOLUTE MAXIMUM RATINGS QFN8 (2 x 3mm) ..................... 55 ...... 12 ... C/W IN, PG, FB to GND.......................... -0.3V to +7V EN to GND ............................. -0.3V to V +0.3V IN Notes: OUT ...................................... -0.3V to V + 0.3V 1) Exceeding these ratings may damage the device. IN 2) The maximum allowable power dissipation is a function of the (2) Continuous Power Dissipation (T = +25C) A maximum junction temperature T (MAX), the junction-to- J .2.27W ambient thermal resistance , and the ambient temperature JA TA. The maximum allowable continuous power dissipation at Junction Temperature ............................... 150 C any ambient temperature is calculated by P (MAX)=(T (MAX)- D J Lead Temperature .................................... 260 C T )/ . Exceeding the maximum allowable power dissipation A JA will cause excessive die temperature, and the regulator will go Storage Temperature .............. -65C to +150 C into thermal shutdown. Internal thermal shutdown circuitry (3) protects the device from permanent damage. Recommended Operating Conditions 3) The device is not guaranteed to function outside of its Input Voltage V ........................... 1.35V to 6.5V IN operating conditions. 4) Measured on JESD51-7 4-layer board. Output Voltage ................................... 0.5V to 5V Load Current ........................... 500mA Maximum Maximum Junction Temp. (T ) ............... +125 C J MP2002 Rev. 1.11 www.MonolithicPower.com 2 10/10/2011 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited. 2021 MPS. All Rights Reserved.