Precision Systems for the Electronics Bench APR-5000 Users Manual Specifications Introduction & General Overview System Features and Accessories Set-up Software Operation Calibration Nozzles and Vacuum Tubes Spare Parts and Accessories Site Preparation Warranty & Service www.okinternational.com - 1 - 7000-1370 D TABLE OF CONTENTS PREFACE Safety and Regulatory Information APR-5000 Series Main Unit Specifications SECTION I Introduction and General Overview SECTION II System Features and Accessories SECTION III Set-Up Procedures SECTION IV Software Operation SECTION V Hardware Trouble Shooting, Optical and Head Calibration SECTION VI Nozzles, Vacuum Pick-up Nozzle and Accessories SECTION VII Calibration Kit and Spare Parts SECTION VIII Site Preparation SECTION IX Warranty and Service PREFACE SAFETY AND REGULATORY INFORMATION WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE SYSTEM TO MOISTURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE FLAMMABLE SOLVENTS NEAR OR ON THE SYSTEM WHILE CONNECTED TO POWER SOURCE. TO PREVENT POSSIBILITY OF INJURY OR DAMAGE TO THE SYSTEM, DO NOT OPERATE WITH ANY COVERS OR PANELS REMOVED. CHANGES OR MODIFICATIONS MADE TO THIS PRODUCT WITHOUT EXPRESS APPROVAL FROM OK INTERNATIONAL COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. Read and understand the entire Operators Manual before installation or operation of the APR-5000. Heed all warnings on the system and in the operating instructions. Use of the APR-5000 is intended only for the removal and placement of electronic components on to printed circuit boards by properly trained personnel. If you are not familiar with the proper and safe operation of the APR-5000, do not operate until proper training has been obtained. - 2 -