INL-5ABCMIR30 5mm Infrared Emitting Diode Though Hole Lamp LED Features Description High reliability The infrared emitting diode (880nm) is a high intensity diode, molded in a blue clear transparent General purpose leads plastic package. Peak wavelength p=880nm The device is spectrally matched with silicon Mechanically and spectrally matched to the photodiode and phototransistor. phototransistor Low forward voltage High radiant intensity Applications Optoelectronic Switch IR Touch-Panel Industrial IR Equipment Consumer Electronics High Speed IR Communications Package Dimensions in mm Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25 mm (.010 ) unless otherwise noted. Figure 1. INL-5ABCMIR30 Package Dimensions Inolux Corporation January, 19, 2019 www.inolux-corp.com Proprietary & Confidential Page 1 INL-5ABCMIR30 5mm Infrared Emitting Diode Though Hole Lamp LED o Absolute Maximum Rating at 25 C (Note 1) Emission o o P (mW) I (mA) I * (A) V (V) Product d F FP R T ( C) T ( C) OP ST Color o o o o INL-5ABCMIR30 Infrared 160 100 1 5 -40 C~+80 C -40 C~+85 C Notes 1. Condition for IFP is pulse of 1/10 duty and 1kHz frequency Electrical Characteristics T = 25C (Note 1) A Viewing V (V) (nm) Ee(mW/sr) F Angle Emission Product I (mA) F Color min max 2 1/2 min typ. D P INL-5ABCMIR30 Infrared 20 1.0 1.6 - 880 45 30 6.5 13 Notes 1. Performance guaranteed only under conditions listed in above tables. ESD Precaution ATTENTION: Electrostatic Discharge (ESD) protection The symbol above denotes that ESD precaution is needed. ESD protection for GaP and AlGaAs based chips is necessary even though they are relatively safe in the presence of low static-electric discharge. Parts built with AlInGaP, GaN, or/and InGaN based chips are STATIC SENSITIVE devices. ESD precaution must be taken during design and assembly. If manual work or processing is needed, please ensure the device is adequately protected from ESD during the process. Please be advised that normal static precautions should be taken in the handling and assembly of this device to prevent damage or degradation which may be induced by electrostatic discharge (ESD). Inolux Corporation January, 19, 2019 www.inolux-corp.com Proprietary & Confidential Page 2