MiCS-2714 Data Sheet 1107 rev 6 The MiCS-2714 is a compact MOS sensor. The MiCS-2714 is a robust MEMS sensor for nitrogen dioxide and leakage detection. Features Smallest footprint for compact designs (5 x 7 x 1.55 mm) 100.00 NO2 Robust MEMS sensor for harsh environments High-volume manufacturing for low-cost 10.00 applications Hydrogen Short lead-times 1.00 NO 0.10 0.01 Detectable gases 0.01 0.1 1 10 100 Concentration ppm Nitrogen dioxide NO 0.05 10ppm 2 Hydrogen H 1 1000ppm 2 Continuous power ON, 25C, 50% RH For more information please contact: info.em sgxsensortech.com SGX Sensortech, Courtils 1 CH-2035 Corcelles-Cormondrche Switzerland www.sgxsensortech.com Page 1 of 5 Rs/R0MiCS-2714 Data Sheet 1107 rev 6 Performance sensor Characteristic Symbol Typ Min Max Unit OX sensor Sensing resistance in air (see note 1) R - 0.8 20 k 0 Typical NO detection range FS 0.05 10 ppm 2 Sensitivity factor (see note 2) S - 2 - - 60 Notes: 1. Sensing resistance in air R is measured under controlled ambient conditions, i.e. synthetic air at 23 0 5C and 50 10% RH. Sampling test. 2. Sensitivity factor is defined as Rs at 0.25 ppm NO , divided by R in air. Test conditions are 23 5C 2 S and 5% RH. Indicative values only. Sampling test. IMPORTANT PRECAUTIONS: Read the following instructions carefully before using the MiCS-2714 described here to avoid erroneous readings and to prevent the device from permanent damage. The sensor must be reflow soldered in a neutral atmosphere, without soldering flux vapours. The sensor must not be exposed to high concentrations of organic solvents, silicone vapours or cigarette-smoke in order to avoid poisoning the sensitive layer. Heater voltage above the specified maximum rating will destroy the sensor due to overheating. This sensor is to be placed in a filtered package that protects it against water and dust projections. SGX sensortech strongly recommends using ESD protection equipment to handle the sensor. Page 2 of 5