Magnetic Proximity Sensors (Hall Effect) MP1014 Sensors Digital Hall-effect position sensor in low-profile flange-mount housing Description The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output. Features Typical Applications Solid state reliability Door position & interlock South pole sensitive Limit switch Unipolar device Flow/speed RoHS compliant Home security Low profile design Pedal switch IP65 Environmental Specifications Operating Temperature -40 C to 85 C (-40 F to 185 F) StorageTemperature -40 C to 100 C (-40 F to 212 F) Ingress Protection IP65 Electrical Specifications Operating Supply Voltage (MP101401) 4.5 to 18 VDC Operating Supply Voltage (MP101402) 4.5 to 24 VDC Supply Current 3.0 mA typ., 5.2 mA max. Output Current (Sink) 20 mA max. Maximum Reverse Voltage (MP101401) 18 VDC Maximum Reverse Voltage (MP101402) 15 VDC Pull-Up Resistor See chart Mechanical Specifications Housing Material Glass-reinforced nylon plastic Products Part Number Leads MP101401 24 AWG x 314 mm MP101402* 24 AWG x 314 mm *Not commonly stocked Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k www.cherryswitches.com Page 1 of 2, last update 2014-10-29, Specifications subject to change without notice. Open Collector Sinking Block Diagram Dimensions mm (inches) www.cherryswitches.com Page 2 of 2, last update 2014-10-29, Specifications subject to change without notice.