VDV526-200

ENGLISH VDV526-200 INSTRUCTION MANUAL LAN Scout Jr. 2 NOTE: Pull out tab on back of tester before first use. DEUTSCH pg. 9 FRANAIS pg. 17 ESPAOL pg. 25ENGLISH GENERAL SPECIFICATIONS TESTER PORTS, BUTTONS & DISPLAY The Klein Tools LAN Scout Jr. 2 is a portable data cable tester. It tests and TESTER (FIG. 1 & FIG. 2) troubleshoots RJ45 terminated cables and provides tone generation for FIG 1 - RJ45 shielded jack FIG 2 - Removable docked remote with Shielded cable tracing. RJ45 jack Dimensions: 5.3 x 2.4 x 1.2 (13.5 x 6.1 x 3.0 cm) BUTTONS (FIG. 3) Weight: 4.0 oz. (115 grams) with battery and remote Test Button A performs wire map test on RJ45 terminated cable. Operating temperature: 0C to 50C / 32F to 122F B Tone Button transmits analog tones on conductor wires of RJ45 terminated Storage temperature: -20C to 60C / -4F to 140F cables. Button also cycles through available tone cadences and conductor wire Humidity: 10% to 90%, non-condensing selection options. Maximum Voltage between any two connector pins without damage: Power/Backlight Button C turns unit on or off, turns backlight on or off. RJ Jack: 66V DC or 55V AC Battery Life typical: 2x AAA Alkaline batteries Standby: 3 years Active: 80 hours Cable types: Shielded or Unshielded Cat-7, Cat-6/6A, Cat-5E, Cat-3 Maximum Cable Length: 2000 feet (610 meters) Minimum Cable Length for Split pair Detection: 1.5 feet (0.5 meters) WARNINGS FIG. 1 To ensure safe operation and service of the tester, follow these instructions. FIG. 3 Failure to observe these warnings can result in severe injury or death. The LAN Scout Jr. 2 is designed for use on unenergized cabling systems. A Connecting the LAN Scout Jr. 2 to live AC power may damage it and pose a safety hazard for the user. Improperly terminated RJ plugs have the potential to damage the jacks on the LAN Scout Jr. 2. Visually inspect an RJ plug before inserting it into the tester. Plugging 6-position plugs into the 8-position jack on the tester has the potential to damage the outer-most contacts of the jack unless the plug is B specifically designed for that purpose. FIG. 2 SYMBOLS ON TESTER Warning or Caution C Always wear approved eye protection Do NOT use on energized circuits Read instructions Conformit Europenne - Conforms with European Economic Area directives This symbol indicates that equipment and its accessories shall be subject to a separate collection and correct disposal 2 3