CYLO5BE

Report Date : 09/03/2011 REVISION DATE NOVEMBER 2010 MATERIAL SAFETY DATA SHEET CYANOLUBE 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING PRODUCT NAME CYANOLUBE PRODUCT NO. CYL ECYL05B ECYL05BE ECYL20B APPLICATION Cyanoacrylate adhesive SUPPLIER H K WENTWORTH PTY LIMITED P.O. BOX 339 BROOKVALE, NSW 2100 AUSTRALIA TEL: 02 9938 1566 FAX: 02 9938 1467 GENERAL MANAGER EMERGENCY TELEPHONE Tel: 029938 1566 between 8.30am and 5.00pm EST 2 HAZARDS IDENTIFICATION RISK PHRASES R36/37/38 Irritating to eyes, respiratory system and skin. SAFETY PHRASES S24/25 Avoid contact with skin and eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S37 Wear suitable gloves. S51 Use only in well-ventilated areas. P3 Cyanoacrylate. Danger. Bonds skin and eyes in seconds. Keep out of reach of children. The above phrases are the risks associated with the product STATEMENT OF HAZARDOUS NATURE HAZARDOUS SUBSTANCE (According to criteria of NOHSC). NON-DANGEROUS GOODS (According to ADG Code). 3 COMPOSITION/INFORMATION ON INGREDIENTS Name EC No. CAS-No. Content % Classification (67/548) ETHYL 2-CYANOACRYLATE 230-391-5 7085-85-0 80-100% Xi R36/37/38 The Full Text for all R-Phrases is Displayed in Section 16 COMPOSITION COMMENTS Ingredients not listed are classified as non-hazardous or at a concentration below reportable levels Ingredients are registered on AICS 4 FIRST-AID MEASURES NOTES TO THE PHYSICIAN Treat symptomatically INHALATION Move the exposed person to fresh air at once. Rinse nose and mouth with water. Get medical attention if any discomfort continues. INGESTION Rinse mouth thoroughly. Drink plenty of water. Get medical attention. SKIN CONTACT Wash the skin immediately with soap and water. Get medical attention if irritation persists after washing. 1 / 4 Report Date : 09/03/2011 REVISION DATE NOVEMBER 2010 CYANOLUBE EYE CONTACT Make sure to remove any contact lenses from the eyes before rinsing. Promptly wash eyes with plenty of water while lifting the eye lids. Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues. 5 FIRE-FIGHTING MEASURES EXTINGUISHING MEDIA This product is not flammable. Use fire-extinguishing media appropriate for surrounding materials. 6 ACCIDENTAL RELEASE MEASURES SPILL CLEAN UP METHODS Wear necessary protective equipment. Absorb in vermiculite, dry sand or earth and place into containers. 7 HANDLING AND STORAGE USAGE PRECAUTIONS Avoid spilling, skin and eye contact. STORAGE PRECAUTIONS Store in tightly closed original container in a dry, cool and well-ventilated place. Keep in original container. 8 EXPOSURE CONTROLS/PERSONAL PROTECTION PROTECTIVE EQUIPMENT ENGINEERING MEASURES No particular ventilation requirements. Provide adequate ventilation. Observe Occupational Exposure Limits and minimise the risk of inhalation of vapours. RESPIRATORY EQUIPMENT No specific recommendation made, but respiratory protection must be used if the general level exceeds the recommended occupational exposure limit. HAND PROTECTION Use protective gloves. EYE PROTECTION Use approved safety goggles or face shield. OTHER PROTECTION Wear appropriate clothing to prevent any possibility of skin contact. HYGIENE MEASURES DO NOT SMOKE IN WORK AREA Wash at the end of each work shift and before eating, smoking and using the toilet. Wash promptly if skin becomes wet or contaminated. When using do not eat, drink or smoke. 9 PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE Liquid COLOUR Colourless ODOUR Strong. BOILING POINT (C) >200 (392 F) RELATIVE DENSITY n/a c VISCOSITY <2000 mPas FLASH POINT (C) >100 (212 F) CC (Closed cup). 10 STABILITY AND REACTIVITY STABILITY Stable under normal temperature conditions. CONDITIONS TO AVOID Avoid heat, flames and other sources of ignition. Avoid contact with acids and alkalis. 2 / 4