BOSCH SCHMELZKLEBER SCHWARZ Bosch

Safety Data Sheet according to (EC) No 1907/2006 - ISO 11014-1 Page 1 of 4 SDS no. : 43776 V001.6 CX 122 Bosch 2607001178 Revision: 17.09.2007 printing date: 09.10.2007 1. Identification of the substance/preparation and of the company/undertaking Trade name: CX 122 Bosch 2607001178 Intended use: assembly adhesive Company name: Henkel KGaA Henkelstr. 67 40191 Dsseldorf Germany Phone: +49 (211) 797-0 E-mail address of person responsible for Safety Data Sheet: ua-productsafety.de henkel.com Emergency information: The Henkel information service also provides an around-the-clock telephone service on phone no.++49-(0)211-797-3350 for exceptional cases. 2. Hazards identification The product is not hazardous within the meaning of the valid (EU) preparation guideline. 3. Composition / information on ingredients General chemical description: Hotmelt adhesive Base substances of preparation: Ethylene-vinyl acetate copolymer Declaration of ingredients according to EC/1907/2006: Contains no dangerous substances exeeding the limits of the EU-Directive 4. First aid measures General information: If unconscious place recovery position and inform emergency services. Inhalation: Fresh air, oxygen supply, warmth seek specialist medical attention. Skin contact: After contact with the hot melt: cool with water, seek medical attention. MSDS-No.: 43776 CX 122 Bosch 2607001178 Page 2 of 4 V001.6 Eye contact: After contact with the hot melt: cool with water, seek medical attention. Ingestion: If adverse health effects develop seek medical attention. 5. Fire fighting measures Suitable extinguishing media: All common extinguishing agents are suitable. Extinguishing media which must not be used for safety reasons: High pressure waterjet Special protection equipment for firefighters: Wear self-contained breathing apparatus. Hazardous combustion products: carbon monoxide 6. Accidental release measures Personal precautions: Not needed. Environmental precautions: Do not empty into drains / surface water / ground water. Clean-up methods: Allow to solidify. Remove mechanically. 7. Handling and storage Handling: Ensure that workrooms are adequately ventilated. Storage: Ensure good ventilation/extraction. Store in a cool, dry place. 8. Exposure controls / personal protection Components with specific control parameters for workplace: none Engineering controls: Ensure good ventilation/extraction. Respiratory protection: Suitable breathing mask when there is inadequate ventilation. Hand protection: Wear refractive gloves while working with the hot melt. Eye protection: Protective goggles