YB26WCKW01/CUL-5C-JC

Series WR Environmentally Sealed Rockers General Specifications Electrical Capacity (Resistive Load) B Power Level: 15A @ 125/250V AC or 15A @ 30V DC Other Ratings Contact Resistance: 10 milliohms maximum for solder lug, screw & quick connect terminal models 30 milliohms maximum for wire lead terminal models Insulation Resistance: 200 megohms minimum @ 500V DC Dielectric Strength: 1,250V AC minimum between contacts for 1 minute minimum 3,750V AC minimum between contacts & case for 1 minute minimum Mechanical Life: 30,000 operations minimum Electrical Life: 15,000 operations minimum for circuit 11 and 12 models 10,000 operations minimum for circuit 13, 15, 18, 19 models Angle of Throw: 24 Materials & Finishes Rocker: Phenylene oxide Outer Housing: Polyamide (UL94V-0) Inner Case: Melamine (UL94V-0) Cover for Wire Lead Models: Glass fiber reinforced polyamide (UL94V-0) Flange Gasket: Nitrile butadiene rubber Movable Contactor: Copper with silver plating Movable Contacts: Silver alloy plus copper with silver plating Stationary Contacts: Silver alloy plus copper with silver plating Terminals: Brass with tin plating Wire Lead Covers: Heat resistant polyvinyl chloride (Leads are AWG 14) Environmental Data Operating Temp Range: 25C through +85C (13F through +185F) Humidity: 90 ~ 95% humidity for 96 hours @ 40C (104F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Front Panel Seal: IP67 of IEC60529, dust tight & water protected during temporary immersion for all models Behind Panel Seal: IP60 of IEC60529, dust tight but not water protected for solder lug, screw & quick connect models IP67 of IEC60529, dust tight & water protected during temporary immersion for wire lead models Installation Soldering Time & Temp: Manual Soldering: See Profile A in Supplement section. Cleaning: Hand clean locally using alcohol based solution. Standards & Certifications Flammability Standards: UL94V-0 outer housing, inner case, & outer cover on wire lead models UL: File No. E44145 - Recognized only when ordered with marking on switch. Add /U or /CUL to end of part number to order UL recognized switch. All models approved at 15A @ 125/250V AC & 15A @ 30V DC. EN: No. 61058-1 WR11 & WR12 models meet European Norm for 3mm contact gap to prevent contact welds. Wiring Material Standards: UL AWM 1015 Recognized at Flammability VW-1. Temperature Range 20C ~ +105C; Maximum Load 600V; AWG 14. CSA TEW 105 Certified at Temperature Range 20C ~ +105C; Maximum Load 600V. B124 www.nkkswitches.com 7/27/18 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesEnvironmentally Sealed Rockers Series WR Distinctive Characteristics B Single unit construction of the flange and outer housing gives added protection from environmental elements. Specially designed contact mechanism for breaking light welds. Minimal contact bounce achieved with specially designed interlocked switching mechanism. Heat resistant resin used for outer housing, inner case, and cover on wire lead models meets UL94V-0 flammability standard and provides high arc and tracking resistance. Available with solder lug, screw, quick connect, and wire lead terminations. Sealed Construction Meets IP60 & IP67 Standards Actual Size Solder lug, screw, and quick connect terminal models meet IP67 of IEC60529 Standards at front panel (dust tight and water protected for temporary immersion, patent pending). Behind panel standard is IP60 (dust tight but not water protected). Wire lead models conform fully to IP67 of IEC60529 Standards at front and behind panel (dust tight and water protected for temporary immersion). Switch base is epoxy sealed and covered by an outer case for further protection from dust and water. (Switches cannot be operated under water. Contact factory for further details regarding operating environment.) www.nkkswitches.com B125 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles