NSL-32SR2

Optocoupler NSL-32SR2 Advanced Photonix, Inc. WWW.ADVANCEDPHOTONIX.COM Precision Control Results 5.7 min. 25.4 min. Anode lead 0.25 x 0.51 Photocell 2.54 + + LED Photocell LED - - 0.45-0.56 3.30 Circuit Schematic cell leads Color dot 6.0 - 6.5 5.72 - 6.22 Cathode lead Dimensions in mm. 0.25 x 0.64 Lead spacing tolerance: +/-0.13 DESCRIPTION FEATURES This optocoupler consists of an LED input optically coupled to a photocell. Compact, moisture resistant package The photocell resistance is high when the LED current is off and low Low LED current resistance when the LED current is on. Passive resistance output RELIABILITY APPLICATIONS CdS/CdSe photo resistors are temperature sensitive, it should be noted Industrial sensing that operation of the photocell above +75C does not usually lead to catastrophic failure but the photoconductive surface may be damaged leading to irreversible changes in sensitivity Contact API for recommendations on specific test conditions and procedures. ABSOLUTE MAXIMUM RATINGS Isolation Voltage 2000 V T = 23C a Operating Temperature -40 to +75 C non condensing Storage Temperature -40 to +75 C >0.05 from case for < 5 sec. Soldering Temperature +260 C (1) Derate linearly to 0 at 75 C (2) Measured after 1 minute ON @ IF = 20mA and followed by 10 sec. OFF. (3) Print NSL-32SR2 and date code YYWW Information in this technical datasheet is believed to REV 12-02-15 be correct and reliable. However, no responsibility is Page 1/2 assumed for possible inaccuracies or omission. 2015 Advanced Photonix, Inc. All rights reserved. Specifications are subject to change without notice. Advanced Photonix Inc. 1240 Avenida Acaso, Camarillo CA 93012 Phone (805) 987-0146 Fax (805) 484-9935 Optocoupler NSL-32SR2 Advanced Photonix, Inc. WWW.ADVANCEDPHOTONIX.COM Precision Control Results T = 23C unless noted otherwise OPTO-ELECTRICAL PARAMETERS a PARAMETER TEST CONDITIONS MIN TYP MAX UNITS LED Forward Current 25 mA Forward Voltage I = 20mA 2.5 V F Reverse Current V = 4V 10 A R Cell Maximum Cell Voltage (Peak AC or DC) 60 V Power Dissipation (1) 50 mW Coupled On Resistance I = 20mA 40 F I = 1mA 140 F Off Resistance (2) 10 sec after IF = 0 mA, 5 V dc on cell 1 5 M Time for the dark to light change in conductance Rise Time 5 msec. to reach 63% of its final value Decay Time Time to reach 100 K after removal of IF =16 mA 5 msec. Cell Temp. Coefficient I > 5 mA 0.7 %/C F Resistance vs. Current 10000 1000 100 10 0.1 1 10 100 Current (mA) Information in this technical datasheet is believed to REV 12-02-15 be correct and reliable. However, no responsibility is Page 2/2 assumed for possible inaccuracies or omission. 2015 Advanced Photonix, Inc. All rights reserved. Specifications are subject to change without notice. Advanced Photonix Inc. 1240 Avenida Acaso, Camarillo CA 93012 Phone (805) 987-0146 Fax (805) 484-9935 Resistance ( W)