1175603

D Operating Instructions SMD LED Light ML DN 2806 S IP54 / ML DN 4006 S IP54 / L DN 2806 S IP54 Please note: Please read these instructions carefully prior to mounting the light and store them in a safe location afterwards TEc HNIca L DaTa: Type of protection: IP 54 Protection class: I Nominal voltage: 220 240 V~ 50/60 Hz Operating temperature: -20C +40C a rticle: Output: c onnection cable: Dimensions (mm) weight: ML DN 2806 S IP54 20 W 2 m H05RN-F 3G1.0 194 x 210 x 326.5 1800 g ML DN 4006 S IP54 30 W 2 m H05RN-F 3G1.0 194 x 210 x 326.5 1800 g L DN 2806 S IP54 20 W 3 m H05RN-F 3G1.0 194 x 80 x 194 1150 g Pr OPEr INTENDED u SE: This high-performance LED lamp is for lighting interior and exterior areas (e.g. workshops, camping, garage, household, etc.). The LED lamp is delivered, ready to connect, with a connection line and ground contact plug. All models are spray water-resistant. Any other use than those described above or modifications to the device are not permitted. OPEra TION: ML DN 2806 S IP54 / ML DN 4006 S IP54 Place on a dry, flat surface. The lamp can be switched on and off using the switch on the rear side. L DN 2806 S IP54 The lamp can be installed on a suitable tripod. Make sure the tripod is sufficiently stable and the lamp is securely installed. Installation height: <3 m. 5 BA SMD LED-Leuchte 0487226 240707.indd 5 24.07.15 13:46Operating Instructions SMD LED Light D Saf ETy N OTES: 1. P rior to commissioning, make sure the right voltage is available. 2. Prior to each use, make sure the light and mains supply cable are not damaged in any way. Never use the lamp if you find damage. c aution a damaged light or mains supply cable pose a risk to life due to electric shock 3. Do not use this light without properly attached gaskets 4. Do not use the work lamp in explosive environments in which flammable liquids, gases or dusts are present. r isk to life 5. LED lights are extremely bright. Do not look directly at the lamp. 6. Damaged protective covers must be replaced with an original Brennenstuhl protective cover before the light can be used again. 7. If the mains supply cable of the device is damaged it must be replaced by a qualified technician in order to avoid risks. 8. M ake sure the light is attached firmly and securely. Make sure the cable is not crimped or otherwise damaged. 9. Keep children away from the lamp. Children cannot estimate the risk of electric shock. Screws Fastening screw Spring washers Flat washers Spring washer Flat washer 6 BA SMD LED-Leuchte 0487226 240707.indd 6 24.07.15 13:46