CY3280-22X45 Infineon

From the Device menu, select CY8C22545-24AXI Click Program.Programming Succeeded.. appears in the Actions pane when programming is completed Click Toggle Device Power. The D1 and D2 LEDs on the CY3280-22X45 board lights red 5. Test the Board Touch one or more buttons at a time. Each button touch lights up the corresponding LED. You can touch multiple buttons simultaneously. 6. Design Support and Resources A wealth of information about PSoC Designer and CapSense Best Practices are available on the www.cypress.com web site. For knowledge base articles, customer forums, and online application support, visit www.cypress.com/go/support. CY3280-22X45 Universal CapSense Controller Development Kit Quick Start Doc. 001-51973 Rev. *A 2009-2011 Cypress Semiconductor Corporation. PSoC Designer and Programmable System-on-Chip are Cypress Semiconductor trademarks, and PSoC and CapSense are registered trademarks of Cypress Semiconductor Corp. All other trademarks or registered trademarks referenced herein are property of the respective corporations. 198 Champion Court San Jose, CA 95134-1709 If you have questions, call Cypress Customer Support Phone (USA): 800.858.1810 +1 (800) 541-4736 Ext. 8 (in the USA), Phone (Intnl): 408.943.2600 +1 (408) 943-2600 Ext. 8 (International), Cypress Semiconductor Corporation 1. Kit Contents 3. Getting Started Each CY3280-22X45 kit contains: The example firmware is available on the CD. Insert the CY3280-22X45 Kit CD into CY3280-22X45 Universal CapSense Controller Board the CD drive of your PC. Follow the instructions to complete software installation. For CY3280-22X45 Universal CapSense Controller Board CD more information, refer to the CY3280-22x45 Universal Capsense Controller CY3240-I2CUSB Board Development Kit Guide available on the CD. CY3210-MiniProg1 Programmer Note The example in this Quick Start is for the CY3280-22X45 Universal CapSense Printed Documents Controller Board and CY3280-SLM Universal CapSense Linear Slider Module Board. Prerequisites: CY3280-SLM Universal CapSense Linear Slider Module Board 4. Code Example CY3215-ICE This example demonstrates the use of CY3280-22X45 Universal CapSense Controller CY3250-22X45 Pod with CY3280-SLM. These instructions assume that your board is programmed with Universal CapSense Module boards are available for purchase separately, or as part the factory settings. of the combination kits. Do visit www.cypress.com for more information. Connect the CY3280-SLM board to the CY3280-22X45 Universal CapSense Controller board s P2 receptacle connector 2. Module Hardware This kit contains the components and sensors detailed in this figure. Place shunts on pins 2 and 3 of JP1 and pins 1 and 2 of JP4 (default setting) Place shunts on pins 2 and 3 of JP2 on CY3280-SLM board The code examples are available on the CD and on www.cypress.com search for CY3280-22X45 To reset the board to the factory conditions, connect your computer to the CY3280-22X45 board ISSP connector (J3) using the PSoC MiniProg and a USB cable Open PSoC Programmer by going to the Windows Start menu All Programs > Cypress > PSoC Programming > PSoC Programmer Click File Load and open the CY3280 22X45 SLM.hex file on the CD at: Firmware CY3280 22X45 SLM CY3280 22X45 SLM.hex From the Device Family menu, select 22X45 Page 2 Page 3