cs-anavi-01 Crowd Supply

AANNAAVVII IInnffrraarreedd ppHHAATT CCoonnvveerrtt YYoouurr RRaassppbbeerrrryy PPii ttoo PPoowweerrffuull RReemmoottee CCoonnttrrooll DDIISSCCLLAAIIMMEERR Raspberry Pi and the Raspberry Pi logo are registered trademarks of the Raspberry Pi Foundation. ANAVI, the ANAVI logo and combinations thereof, are registered trademarks of Leon Anavi. Other product names may be trademarks of others and the rights belong to their respective owners. The information in this document is provided in connection with Anavi products. No license, express or implied or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Anavi products. This work is licensed under the Creative Commons Attribution-ShareAlike 3.0 Unported License. To view a copy of this license, visit BBooaarrdd VVeerrssiioonn Revision 1.0 of ANAVI Infrared pHAT was used while writing this document. It is possible that it is outdated so it is always recommended to check the latest sources from the GitHub page of the board. CCHHAAPPTTEERR 22:: GGeettttiinngg SSttaarrtteedd EElleeccttrroossttaattiicc WWaarrnniinngg ANAVI Infrared pHAT is shipped in a protective antistatic bag. The HAT as well as the Raspberry Pi must NNOOTT be exposed to high electrostatic potentials. A grounding strap or similar protective device should be worn when handling the board. Avoid touching the component pins or any other metallic element. RReeqquuiirreemmeennttss In order to setup ANAVI Infrared pHAT the following items are required: Compatible Raspberry Pi microSD card with compatible image USB power supply Additionally you may attach USB mouse, keyboard, HDMI monitor or addition peripheral devices to your Raspberry Pi. It is recommended to use 2.5A (2500mA) power supply. SSuuppppoorrtteedd PPeerriipphheerraallss ANAVI Infrared pHAT Raspberry Pi HAT has an infrared receiver and an infrared transmitter. Up to 3 I2C sensors can be also easily attached to the pHAT. SSeennssoorrss The officially supported I2C sensor modules by ANAVI Infrared pHAT are: Temperature and barometric pressure (BMP180) Temperature and humidity (HTU21) Light (BH1750) You may also attach any other I2C sensors but you will have to take care of their software integration. TTeemmppeerraattuurree SSeennssoorr The official temperature sensor for ANAVI Infrared pHAT is BMP180. This is I2C sensor capable of measuring both temperature and barometric pressure. Using 4 Dupont jumper wires connect BMP180 to one of the 3 I2C slots on ANAVI Infrared pHAT as follows: AANNAAVVII IInnffrraarreedd BBMMPP118800 ppHHAATT VIN 3.3V GND GND SCL SCL SDA SDA HHuummiiddiittyy SSeennssoorr The official humidity temperature for ANAVI Infrared pHAT is HTU21 (SHT21). This is I2C sensor capable of measuring both humidity and temperature. Using 4 Dupont jumper wires connect HTU21 to one of the 3 I2C slots on ANAVI Infrared pHAT as follows: AANNAAVVII IInnffrraarreedd HHTTUU2211 ppHHAATT VIN 3.3V GND GND SCL SCL SDA SDA